Heart Bracelet

Hearts in a Row Bracelet

36” ‘010 gauge Stainless steel with nylon coated wire

Magnetic clasp (Gold or Silver)

2 ½ Safety chain to match the gold or silver clasp

2 crimp beads (2 by 2) to match the clasp

49 4mm bicone beads for one color heart (quantity may vary based on the size of bracelet)

        COLOR A

51- 4mm bicone beads for the other heart (quantity may vary based on the size of bracelet)

   COLOR B

Crimper and wire cutter (or scissors)

Attaching the clasp

1-     Thread the magnetic clasp and safety chain onto the wire

2-     Put two end of the wire together and thread crimp bead onto both wires and push all components to the folded center of the wire, which should be the other end.

3-     Crimp the crimp bead

Bracelet

4-     Thread bead A on one wire and cross thru with the other wire in the opposite direction/. Make sure you balance the bead in the center

5-     Thread one bead A on each wire

6-     Thread bead B on one wire and cross thru with the other wire in the opposite direction

7-     Thread one bead B on each wire

8-     Thread bead A one wire and cross thru with the other wire in the opposite direction.

9-     Repeat steps 5 to 8 until desired length.

Ending bracelet

10-  Put two ends of the wire together and thread crimp bead, safety chain and the clasp onto both wires.

11-  Thread both wires back thru the crimp bead going towards the bracelet.

12-  Tighten

13-  Work your way back thru the bracelet with remaining of the wire. (Go thru at least 3 beads)

14-  Crimp the Crimp beads and cut remaining wire.

       It is a beautiful bracelet to make for a friend. Enjoy

                    Joy @ Hilo Ben franklin